Closed
Description
Did you check that your report is not a duplicate?
Yes, I have checked and this is a new bug not previously reported.
Bug Description
On the second BLTouch Testing step, if you press on the "Yes Slowly" button, the tools displays in red the Brown and Red wires but says "Check the orange (Servo) wire". The red and brown wires should be checked at this stage, not the orange one.
Expected behavior
The tool should say: "Check red (VCC) and brown (GND) wires"
Actual behavior
It says "Check the orange (Servo) wire"
Steps to Reproduce
- Go in Tuning / Sensor
- Press Yes on the first step
- Press Yes Slowly on the second step
Version of ADVi3++ Firmware
5.5.0
Printer model
Wanhao Duplicator i3 Plu
Mods
No response
Bed Leveling
No response
Your Slicer
No response
Host Software
No response
Additional information & file uploads
No response