This is a controller for Kaimana Mini LED Driver and Kaimana J2 RGB LED.
- Arduino 1.8.3 and later
- I used this version when I wrote code and I don't have test with older versions.
- Tourney mode
- LED color setting
Tourney mode is to off all LEDs.
Press and hold the START/OPTIONS button at least 3 seconds, then Tourney mode is enabled/disabled and also all LEDs are turned on for about 3 seconds.
In Invert mode, all LEDs are on and pressing a button turns them off.
To enable Invert mode, press and hold the START/OPTIONS button and UP at least 3 seconds in Tourney mode.
To enter setting mode, press and hold the HOME/PS/XB button at least 3 seconds when Tourney mode is disabled.
All LEDs are turned on if it is in selection mode of mapping mode.
To set mapping for each LED/button correctly, you need to do the following process.
- Press any button
- Press lit up button
Recurse this process for all buttons until pressed button and lit up button has been matched.
After finishing to mapped correctly, press and hold the HOME/PS/XB button to leave this mode.
Note that all LED settings (mappings/colors) will be reset when entering this mode.
To enter setting mode, press and hold the SELECT/SHARE/BACK button at least 3 seconds when Tourney mode is disabled.
All LEDs are turned on if it is in selection mode of setting mode.
In that state, press a button you want to set a color of LED.
If you are selecting the button that is move buttons(LEFT, RIGHT, DOWN and UP), attack buttons become setting buttons.
If you are selecting the button that is attack buttons(P and K buttons), move buttons become setting buttons.
| Selected button | P or K |
LEFT, RIGHT, DOWN or UP |
Behavior |
|---|---|---|---|
LEFT |
P1 or K1 |
Increase 15 Red color value | |
DOWN |
P2 or K2 |
Increase 15 Green color value | |
RIGHT |
P3 or K3 |
Increase 15 Blue color value | |
START/OPTIONS |
START/OPTIONS |
Set color and return to selection mode | |
SELECT/SHARE/BACK |
SELECT/SHARE/BACK |
Reset color |
The range of the RGB value is from 0 to 255. if you increase RGB value over 255, it will be started from 0 again.
After finishing to set all LED colors you want, return to selection mode, then press and hold the SELECT/SHARE/BACK button at least 3 seconds to save LED colors you set.
Paradise Arcade Shop Kaimana LED Driver Board Initial Release October 15, 2013
Copyright 2013 Paradise Arcade Shop, ParadiseArcadeShop.com All rights reserved. Use is subject to license terms.
Code is provided for entertainment purposes and use with the Kaimana controller. Code may be copied, modified, resused with this Copyright notice. No commercial use without written permission from Paradise Arcade Shop.
Paradise Arcade Shop Kaimana LED Driver Board Initial Release October 15, 2013
THE SOFTWARE IS PROVIDED "AS IS", WITHOUT WARRANTY OF ANY KIND, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND NONINFRINGEMENT. IN NO EVENT SHALL THE AUTHORS OR COPYRIGHT HOLDERS BE LIABLE FOR ANY CLAIM, DAMAGES OR OTHER LIABILITY, WHETHER IN AN ACTION OF CONTRACT, TORT OR OTHERWISE, ARISING FROM, OUT OF OR IN CONNECTION WITH THE SOFTWARE OR THE USE OR OTHER DEALINGS IN THE SOFTWARE.
The Kaimana class library is based on original source released by ParadiseArcadeShop.com with feedback from the community.
Created: October 24, 2013 zonbipanda -- Arduino 1.0.5 Support
Revised: October 29, 2013 zonbipanda
Revised: April 11, 2015 zonbipanda -- Arduino 1.6.3 Support
_