This is the homepage of the Moon Lamp project, as presented by myself in this YouTube video.
- Support is needed only for the core and the bottom part.
- Add -7.4mm Z axis offset
- 100% infill
- No support
- Use raft
- "CapacitiveSensor" Arduino library
This project is a PlatformIO compatible and can be directly imported into any IDE with PlatformIO installed, such as Visual Studio Code. Alternatively, the code can be deployed through the Arduino IDE as well.
- Breadboard
- Jumper wires
- 1x RGB LED strip SMD 5050
- 3x N-channel MOSFETs IRF 520
- 1x Voltage regulator 5v
- 1x Capacitor 33uF 16v
- 1x Arduino Nano
- 2x Prototype boards 2x8cm/0.8x3.1inch
- 1x Piezo speaker 35mm
- 1x Light-dependent resistor LDR
- 3x 1kOhm resistor
- 4x 10kOhm resistor
- 2x 1MOhm resistor
- 1x 12v Standard power supply US / 12v Standard power supply EU
- 1x 12v Power jack
- Wires 24 awg or similar. I used wires from an ethernet cable.
- Aluminum foil
- Hot glue
- Super glue
- Wood batten for the stand 14x14mm/0.551x0.551 inches; 6 pieces x 60mm(2.36in)
My 3D Printing Gear Creality K1 MAX
Filament that I used for this project: Creality White PLA 1.75mm