A custom acrylic, laser cut computer case for a mini-ITX motherboard, SFX power supply and RTX 3090 FE.
This was created using C and output to an SVG to be laser cut. You can easily change parameters within the code to adjust all aspects of the case.
Note, you will need:
- A Laser Cutter
- A little more than 24x18" of 3/4" (8.5-9mm) acrylic.
- 6x #6-32 3/4" bolts, 6 #6-32 nuts.
- A lot of M3 hardware.
- A 144 LED/meter right-angle LED strip. (You'll need 72 LEDs)
Included for convenience is the SVG from my code.
Run this with the following command:
tcc -run gen_svg.c > case.svg