Home

Usage

Turn on the board by setting the bottom-right switch to ON/battery.
To operate in battery mode, insert a CR2032 or LIR2032 coin cell battery.
- Note: The board does not include a charging circuit. Use a CR2032 (non-rechargeable) unless you have an external charger for LIR2032 (rechargeable) cells.
To turn off the board, set the bottom-right switch to OFF/prog.
- In this position you can power the board externally via the VCC_TOOL & GND on the programmer connector (+3.3V)

Press the MODE button (left button) to cycle through modes.
To start with Advanced modes available:
- Hold MODE and press RESET, or power on the board with MODE held.
- Release the MODE button after the first LED animation completes.

Modes

Hardware