A cute little animal friend that lives in your watch and responds to the things that you do!
❄️ Is it cold outside? Your Garmagotchi will put on a beanie and a scarf to keep warm!
đź’¦ Heart rate high? Your Garmagotchi will be working hard and sweating right there with you!
- Install the Garmin ConnectIQ SDK and follow its setup instructions.
- Install Garmin's MonkeyC vscode extension.
- Set up a dev key by running the
Monkey C: Verify Installationcommand from your VSCode command pallette (cmd-shift-p). NOTE: you must save this file to the repo root. - Make the
connectiqandmonkeycshell commands available by following the setup instructions. - Run
./dev.shfrom your console to start everything up!
- Run
./dev.sh - That's it! Your app will refresh in the sim after yo 8000 u make any change to the source files.
dev-flow-demo.mp4
- (If using Mac) Install Android File Transfer to transfer the PRG file to your watch.
- In VSCode, open the
garmagotchiworkspace and run theMonkey C: Build for Devicecommand from your VSCode command pallette (cmd-shift-p). - Running that command should prompt you to select which watch you'd like to build for, where to save your PRG file, and whether you'd like a debug or release build. Choose the release option.
- Find the
garmagotchi.prgfile in your finder and transfer it to your watch by dragging it it intoGARMIN/apps.