unistagger qaz-like w/ numpad
- MX-Hotswap sockets
- CH552T Controller (w/ FAK firmware), uses japanese duplex matrix
- reversable pcb so you may have numpad right or left
- gerber and case files are supplied (kicad files, stl as well as cadquery files)
- completely open source, permissive license (CERN-OHL-P)
- only V2: removeable numpad, more numpad options
- V2 pcb is not fully tested yet
current version in repo (V2):
V1:
not all stab option are tested with the plate. They should work, but maybe there are cases which require some work on the plate.
All production files you need to build your own board can be found here.
Apart from the pcb and optionally a case you need:
-
50 hotswap sockets
-
58 diodes (1N4148 int SOT-123)
-
50 of your favourite switches
-
1x CH552T (TSSOP-20)
-
1x USBLC6-2SC6 (SOT-23-6)
-
1x 10kOhm resistor (SMD 0603)
-
2x 5.1kOhm resistors (SMD 0603)
-
2x 100nF capacitors (SMD 0603)
-
1x USB Connector C-Type, 12 pin/16pin
-
8 M2 heat inserts
-
8 M 552F 2 srews (8mm)
Config for FAK can be found here). Please also see FAK-Firmware site for more information
Bootloader should be available on plugin until firmware is written. After that either use the firmware BOOT to go into bootloader, or hold the boot button on the pcb pressed while pluggin in the usb cable.
Everything in this repository is free to use however you might see fit. If you want to support me and my projects, please consider linking back to this repository if you build/change/use anything.
If you would like to send me a tip, you could do it here (Please don't feel like you have to).